Bad experience with Armscor 180 FMJ/TC 180

[jamestap]

I ran some through my GP100 yesterday and was a bear to extract.  I had to whack the ejector rod with the handle of my demooner to get them out.

Running factory moons, it would sometimes start to drag after four rounds.  Then I noticed the last two bullets slipping their crimp.

It wasn't the clips, either.  I ran a couple cylinders without moons.  Still hard to extract.

I mostly run .40s in this gun, but I've shot Sig 10s before with no problems.  The cylinder was squeaky clean at the start of the session.