G20 RMR Mount without milled slide

[Kenk]

I would like to mount an RMR on my G20, gen 4, however the slide has not been milled. Any recommendations on a solid mounting system that will hold a zero under 10mm recoil; or is there such a thing?
Thanks

Ken

[Mike D]

I believe they make a rear sight mount for it. Have to replace the rear sight and mount the RMR to the plate that goes in where the rear sight was previously.


Sent from my iPhone using Tapatalk Pro

[Kenk]

Any idea on the manufacturer or cost?
Thanks

Ken

[sqlbullet]

https://www.google.com/search?q=dovetail+RMR+mount&oq=dovetail+RMR+mount

[Kenk]

Thanks sqlbullet, any certain one  that folks have had good success with?

[Soldier of The Law]

I'd sent it to Suarez International to be milled.

[Kenk]

Absolutely, I just hate to be without it

[cwlongshot]

Have you seen the newer Strike Industries mount?

Its a weaver base, so not specifically for the RMR. But having had a GUM base and seeing that it worked, but continued to come loose. I like this one better but it is taller and more obtrusive.

I used the GUM for one season of 3GUN and it works OK, I milled the slide this past winter and much prefer the milled slide. The down time was minimal as I timed it with the smith so he only had it a couple days.

Two weeks back I picked up a Glock 24. I am now contemplating milling its slide... May go with this Strike industries base. OOH you also DO NOT LOOSE the rear site!!

https://www.brownells.com/optics-mounting/electronic-sights/mounting-hardware/rear-sight-rail-adapter-for-glock--prod55590.aspx

https://www.youtube.com/watch?v=TxKmXAe561k

CW

[Kenk]

Nice, and it seems retain its zero?