P carry 10mm sights

[sstewart]

Looking at getting p carry to replace or supplement my shield.
I know the p carry has a cast in place front sight. So milling is. needed. Is there enough metal to dovetail?

Is rear cut Novak or ??
Would CZ95 sights fit this gun?
These look good to me.
https://www.truglo.com/firearms-handgun/brite-site-tfx-handgun-sights.asp?catid=E5FDB84FE8F74C239330C1841BDD3D5E

Posted also on tanfoglio forum area.

[10mmfan]

Looking at getting p carry to replace or supplement my shield.
I know the p carry has a cast in place front sight. So milling is. needed. Is there enough metal to dovetail?

Is rear cut Novak or ??
Would CZ95 sights fit this gun?
These look good to me.
https://www.truglo.com/firearms-handgun/brite-site-tfx-handgun-sights.asp?catid=E5FDB84FE8F74C239330C1841BDD3D5E

Posted also on tanfoglio forum area.

I hope your aware the p carry is much larger than the bodyguard. It is about the size of a 1911 commander.

[sstewart]

The shield is much larger than the bodyguard too.

[sstewart]

So nobody has a witness P carry?

[10mmfan]

So nobody has a witness P carry?

I have one but I don't know the answer

[sstewart]

So nobody has a witness P carry?

I have one but I don't know the answer

So you are using stock sights?
Do you like the gun

[10mmfan]

I am using the stock sights and I do like the gun but holsters are hard to come by.

[sstewart]

I thought Alienware did one. Not true?

[10mmfan]

I thought Alienware did one. Not true?

I tried that but the 10mm slide is wider than the other calibers so it doesn't fit right.

[Intercooler]

Did you look over Henning's sight?

[sstewart]

Did you look over Henning's sight?

i have Hennings on my match. The p carry has a cast in place front sight, so i have a problem there. The rear is dovetail

[Intercooler]

You might want to look into sending your slide to Dawson for the machine work and fitting of their site.

[cwlongshot]

I must admit I did not know what one was...

http://tacticalgunreview.com/eaa-witness-p-carry-10mm-nice-bear-gun/

Looks good...but cracking frame problems???  Ill stick to my Glocks thank you.

CW

[sstewart]

I think the frame cracking is a few years back now. (The rounded top ones; the current ones are more square topped).
I was thinking, since I shoot my witness limited very accurately, this would be a good carry gun. I have a S&W Shield in .40 now.
1) I could just get an APEX kit to make my shield shoot more accurately (for me since I am used to a SA gun with a fairly light pull)
2) Get a Glock 29, but I am sure I would have to get sights & maybe a similar trigger job - $$
3) The P Carry would need sights to be my EDC and maybe a trigger job also

Or just practice more with the Shield. Small guns just are not as accurate as larger ones.

[cwlongshot]

I do like the Shield 40!!



Carries and shoots well.



CW