Glock Longslide

EdMc · August 18 2012 11:41:20 AM MDT

A couple more dumb questions: Does the LW slide require the use of the Glock firing pin channel liner? 'Press fit' doesn't work well with plastic. ${$default_cheesy_smiley}$

Which end does the fiber washer go on the SS rod? Under the screw or at the other end of the spring?

Yondering · August 18 2012 03:02:25 PM MDT

The LW slide uses all of the Glock slide parts, including the channel liner.

The plastic washer goes under the screw on the guide rod.

EdMc · August 19 2012 11:34:16 AM MDT

Now, IF I had a barrel.... ${$default_cheesy_smiley}$

Bro KV · August 19 2012 12:18:14 PM MDT

Quote from: EdMc on August 19 2012 11:34:16 AM MDT
Now, IF I had a barrel.... ${$default_cheesy_smiley}$

Thanks guy!!!!!

I need to stay out of this thread.

Yondering · August 19 2012 01:22:38 PM MDT

That looks good!

EdMc · August 20 2012 01:22:59 PM MDT

Well, Lone Wolf bumped the back order date out another week today. Expected 8/30....... Never had dealings on back orders with them before.......should I expect it before Thanksgiving? ${$default_tongue_smiley}$

Damn, now the expected delivery date is 5 October......might be Christmas ......... ${$default_angry_smiley}$

EdMc · September 22 2012 07:13:47 AM MDT

Gaaaackkk.........BO date extended again..10/26....I may not live long enough to see this thing finished. ${$default_angry_smiley}$

REDLINE · September 25 2012 11:10:08 AM MDT

I'm usually a patient guy. What will get to me is a backorder on a backorder. I'll patiently wait on a backorder, but when any company later backorders the backorder, my patients start swirling down the drain pretty quickly.

Hope you get it by Halloween, if not before! ${$default_cool_smiley}$

EdMc · September 25 2012 02:05:25 PM MDT

Quote from: REDLINE on September 25 2012 11:10:08 AM MDT
I'll patiently wait on a backorder, but when any company later backorders the backorder, my patients start swirling down the drain pretty quickly.

I quite agree.....and after three changes in the BO date since the order I only waited for the opportunity. MrRedbull allowed me that opportunity....I should have a threaded 6.61 inch LW barrel by the end of the week. Thanks again MrRedbull........

EdMc · October 19 2012 10:39:51 AM MDT

Just an update....

The cap head screw took care of the screw catching on the slide around the through hole. First tried some Atlanta Arms 180s at an indoor range with FTE etc. With some handloads (chrono'd 1200 fps in stock 4.6 in barrel) the pistol functioned flawlessly. It's a LW G21 longslide with 10mm LW 6.61 in threaded barrel with their comp, guide rod and 24# spring.