If you have a perfect functioning Glock 10mm please post

[yakmaster60]

I use a G20 Glock with the DPM Triple spring system with the Silver outer spring, and I use Underwood ammo with this spring set up;

With the silver spring I can go between:

Underwood 165 Grain FMJ
underwood 180 Grain FMJ
Underwood 200 Grain FMJ
Underwood 220 Lead Cast rounds

with the Yellow Spring outer I use the:
115 Extreme Defender
140 Grain Defender
Both from Underwood.
I use a Chronograph to record the FPS of the shots I make, and in ALL of the Underwood rounds, it EXCEEDS all FPS claims from Underwood by at least 30 FPS (most are around 50 to 60 FPS Greater than advertised).
I have shot over 1000 rounds over 18 months, and only during the first two months did I have any FTF issues, or until I got the right outer springs figured out on the DPM system. Over the past year not ONE SINGLE FTF happened, and I group (on double tap) 2 to 3 inch groups on 25 to 30 yard target ranges.  I absolutely love my G20, better than any gun I have ever owned. And thanks to Underwood, I can claim that I hit 1705 FPS (802 ME) on there 135 Grain XTP hollow-point on AVERAGE!!!
Take that .357 - 125 grain owners,,,, Eat Poo and LIVE!!!

[Lister]

New Glock 40,  perfect with every thing.  PPU 18o JHP barely ejects but they all have made it out of the gun so far. Lister.

[The_Shadow]

Lister, Congrats and welcome to the forum! 

Best regards and enjoy the site!

[10mmGarand]

Glock 20 GEN3-

Totally stock it runs everything 100% from FBI loads to Underwood 180 & 200 grain, but bulges 20% of Underwood ammo. Also 100% with .40 & KKM conversion barrel.

With KKM 10mm barrel and 20# Wolf recoil spring & non captured steel guiderod it's 100% with everything including Hornady #8 book max loads but Underwood fails to feed 20% of the time and severely flattens primers and blows a few . I have never heard of this.

Underwood is the only boutique heave ammo I've used, so BB and others may do the same thing with this combination.

I need to get a chronograph to see what the book max loads velocity looks like.

[DizzyDean]

Have had a Gen 3 G20 for a few months now. Have put maybe a 1000 rounds through it of various types. Running a Lone Wolf barrel and steel guide rod + lighter trigger connector bar.  Have run Underwood, Buffalo bore, hot hand loads, and a bunch of bulk PPU.  0 failures of any kind.

[Doubletap]

At range today with my new G40 Gen4. 100 rds pmc fmj, 50 rds winchester 175 g jhp.  I had no issues. My dad limp wristed his 1st shot, only 1 time. He is 80+.
Very consistent.  Good grouping.  Shot about 3 inches left at 30 yards.  Will adjust next trip. Did not have proper tools to adjust today. 
Overall very happy with it.

[fltbed]

I've got a few rounds through my Glock 40 now and I can say it's been very reliable.  I've only shot my handloads through it, no factory loads but it has functioned perfectly with everything from light target loads to some fairly stout book loads.

I also have no complaints about the accuracy of the factory barrel.
This is my first 50 yard group off sand bags trying to dial in the FF3.


Jeff

[Ramjet]

Model 20 SF stock has run everything from 105 grain DRT to 220 grain WFN cast not one FTF with stock gun.

Now with my LW Long slide atop I had some issues with the first 100 rounds since then it is rare that ever have any issues now.

Factory ammo runs flawless both setups.

[ericb]

My glock 29sf gen 3 is perfect.

Completely stock

I run my carry ammo:

180gr Speer gdhp 9.2gr pp coal 1.250" and

my practice ammo 180 gr berry fmjfn plated 8.8- 9.0gr pp coal 1.250"
And my plinker range ammo same with 8 to 8.7 gr pp

Others have shot it and fte due to limp writing has surfaced. Never with me.

SHADOW corrected the COAL (was 12.50 but fixed to 1.250")

[cigarman454]

My G20 eats everything

[Captain O]

Mine works. Can't complain.

[AllStrobedUp]

My 20 and 29 run like a top.

[pacapcop]

Gen 3 with a steel guide rod,22lb spring. Run thru a timed course. All by Wolff. U/W's 180 XTP. Thank You.

[Mike D]

I have 3 of them.

G29
G20
G20 long slide

I haven't found anything that Malfunction's in any of them.

[ron556]

Gen 4 G20 + G29, fully stock.
No issues... weaker stuff or Underwood, it all runs.