Grip panels EAA and more

[DenStinett]

The one he sent me fit right out of the Bag

[Tomcat 10]

 Do the Hogue wrap-around grips fit the EAA full size steel 10mm ? (mod. # 999200)

[Intercooler]

Do you have a link?

[DenStinett]

Do the Hogue wrap-around grips fit the EAA full size steel 10mm ? (mod. # 999200)

Yes, with a bit of work, they will fit
You need to sand the Backing Plates a bit, because they intrude on the Mag Well and hang-up the Magazines
They need to be Strrreettched to fit, left to right, a little heat will help here
And, in some cases, the Screw Hole needs to be Keyed a bit toward the edge
But yes, they do fit

[MOUNTAIN WILLIAM]

Has anyone tried a set of Hogue G10's on a large frame Witness? Hogue only lists grips for the small frames.

http://www.hoguestore.com/index.php?main_page=product_info&cPath=116_125_553&products_id=7542

[Tomcat 10]

I ordered the Hogue Wrap-Around , this morning .  I hope I will be able to make them fit EAA 999200 .

[Intercooler]

  Before you even try to put it on you will need to remove some material on the locking pads (plastic). The best way to figure that out is position it in place looking at each side with the opposite side peeled back for viewing. When you get it down to where it is flush with the metal of the mag channel give it a little more clearance (maybe .010"). Don't go too far though as it might not have enough meat to hold in position correctly. Try putting a full magazine in it after you get it on and see if they slide out easily. If not, take a bit more off.