Remington Golden Saber 165GR BJHP loads

[10MMGary]

I am just curious if anyone is doing anything that would fall into the high performance(aka full house 10MM loads)using this projectile. I will be using virgin brass and shooting them through my S&W 610 Classic. Thanks in advance for any info/experience you may care to share.
                                                                                                                                                                                                Gary

[REDLINE]

I would suggest starting here; http://10mm-firearms.com/factory-10mm-ammo-pull-downs/

You will find 3 different Underwood 10mm 165gr weight bullet pull-downs, and more by other manufacturers.

Also, this thread should be posted over in the 10mm Reloading subforum.

[10MMGary]

Indeed it appears I posted in the wrong forum, whoever has the ability please feel free to delete or move my post to its proper location and my apologies for the mis-post. However I did not see anything in the links you posted that would pertain to my question. Personally I have no faith in Corbon as the last 200 rounds of their ammo I purchased had about a 60% ratio of primers coming completely out of pocket when fired through factory stock Glock model 29 and model 20. I then (wrongly) figured I could shoot them through my 610 Classic or Buckeye Blackhawk and all they did then was lock up my revolvers. I once was a Corbon fan, well needless to say I am no longer. I am sitting on approx 3-4 K of .40cal Remington 165GR GS BJHP projectiles that I was smart/lucky enough to buy from MidwayUSA way back in the day, and nearly an equal amount of Remington 230GR GS BJHP projectiles.

[REDLINE]

My bad.  Thought you were partially looking for load data for top performance 165gr bullet weights in 10mm.