Underwood 135 gr

Started by P33v3, February 07 2013 05:54:24 PM MST

Previous topic - Next topic

The_Shadow

#30
Every once in a while, RMR http://www.shop.rmrbullets.com/ will get a run of pulled HST bullets, they will have some pulling marks on them but still perform well.  I've only seen them offered in the 0.400" caliber so far and they usually don't last long.

The crimp marks usually don't affect the reloading of the rounds, however plated rounds if they are crimped too deep, it can cut through the plating...that is not good!

Glock says no to lead or reloaded ammo as their policy.  Polygonal rifling is used in quite a few makes of guns.  About the cast bullets, I shoot my cast bullets from my factory Glock barrels, and accuracy great.  Care and inspection is needed, looking for lead build up or shaved bullet material at the end of the chamber that can prevent full chambering of the rounds.  Bullet Fit and quality lube helps.
The "10mm" I'm Packin', Has The Bullets Wackin', Smakin' & The Slide is Rackin' & Jackin'!
NRA Life Member
Southeast, LoUiSiAna