M&P 10mm?

[4949shooter]

I do think the 4" hits a sweet spot no one else fills with a 10mm.

The Glock 19 of the 10mm world.

They might be onto something with this concept.

[Bruno747]

Looks like that rail has a bit of the glock pignose going on.

I'm excited about this. As I understand, a 2.0 slide can work on a 1.0 frame if the slide stop is swapped over. MP 10c here I come. I have to try swapping the mag follower and slide into my 45c frame and mag.

Guess I'll also have yet another pistol I have to swap goofy sights out first thing just like the goofy ones on my xdm elite 10mm. Time to invest in a proper sight pusher.

[cwlongshot]

I have now been ta three shops looking. Have t seen one yet. I wanna bring a 4" home.

Had a awesome time proving some 200g WFN loads yesterday.

CW

[terdog]

Personally I feel that they missed the mark with the sizes. 4.0 & 4.6? Those are too close for my taste.

I have a G29 and SA Elite 3.8"(10mm) and those work well for MY INTENDED use.  For me, the short barrel should be short enough to make it easier to pack and or conceal. I carry mine for general offroad/back country travel. Either in my chest pak while dirt biking / snowmobiling, or a chest holster/belt holster when I hike or Jeep.

Yes ... size matters! lol

[cwlongshot]

For me the 4.0 is my choice. As I also have the G29,20 & 40. My G20 wears a LW 5.5" ported barrel. The lack of support for barels in G29 keeps mine stock. So tbis will be nice balance between G29 and G20.

Probably be a carry piece over G29. The G29 is my winter carry.

I agree the 4.6 seem lo small a length over the 4. A 4&6 mighta been better. But time will tell.

I have shot all barrel Lengths and altho most say little is lost in the short G29. It is substantial. Up to near 200 fps with top loads. But always 100+ in my testing.

[sparkyv]

I'm curious...which do you favor?

I have a G29 and SA Elite 3.8"(10mm) and those work well for MY INTENDED use.  For me, the short barrel should be short enough to make it easier to pack and or conceal.