EAA Witness Elite Limited ejector shortening project

[Intercooler]

  Today I had some hot stuff but nothing went over 20' and stayed on the concrete. Most were 6'-12' so this mod helps a good bit. If you don't plan on going to another caliber get cutting!!

[NVroundman]

Interesting mod.  I finally took my match to the range this week with the 22 pound spring, still waiting for some of the brass to land.  Might have to give this a try.

[Intercooler]

    It's for sure worth doing if you don't plan on running another top on there. I think another test is in order today swapping the 9mm upper on one of the cut lowers. The 9mm Limited dribbles the brass out at full length, this could cause stoppages on the cut lowers if the brass doesn't clear. We will see in a couple of hours!

[Intercooler]

  With the 9mm top off the Limited installed on the Pro it ran fine. No stoppages and the brass dribbled like the uncut Limited lower.

[StockIIBoss]

Interesting project. I'll be adding this one to the list for sure! Today's range brass showed no signs of ejector damage, but just keeping the distance down would be a plus.