Does anyone have any experience with Montana Gold 357 sig bullets?
Also I have a new mold: 
That I would love to cast some pure linotype boolits with. It is a HG 275 clone 130 gr SWC.  I think they will hold together. In 9mm they are very accurate.


[attachment deleted by admin]

The cast bullets will work in the 9x25 just be sure to work up your data accordingly.

I use several cast bullets in mine, I cast and load a 0.3565" Lyman Devastator hollow point that works well in 9x25 and 357Sig.  This bullet is based off a 147 grain TC but uses a hollow pointer pin and they run 125 to 130 as cast. 
I shoot this one at 1700 fps using 10.6 LS...

Excellent,. That will help keep the cost down a little.

Hi everyone,

The h&g 275 NLG clones that I posted a picture of shoot very well . Worked up to 10.6 grains of Longshot with out any pressure signs and made beautiful rounds holes with the SWC .

Does any one have any advice on a starting point with a 95 grain cast bullet? I usually use Longshot , but also load 10 mm with Blue dot and BE-86. I will cast these 75-25 Linotype /lead and water quench before powder coating. 

I have shot my cast bullets with the same loads as jacketed stuff for mine.  Mine are as cast, air cooled COWW, sized to 0.3565" with White Label Carnauba Red lube.
The 125 grain Lyman Cast HP runs at 1700 fps from the G-20 LW 6" pushed with 10.6 LongShot.