As stated I have 500 of the 135 noslers and I have long shot and 800x.  But I only have fed mag large pistol primers available.

So where is a good place to start as I dont have a nosler manual for some reason.

Thanks

Brian

  I have not seen any data for the 135gr with either of those slow powders.

Nolser data is available free on-line.

http://www.nosler.com/load-data

Nope, only recipes I have for 135 grain jacketed use Accur #5 or #7, Autocomp, Titegroup, HS6, Unique, Blue Dot, or Universal.

Lookie what I found online.

Bullet    Nosler
Bullet Weight    135 grs
Powder    IMR Hi-Skor 800-X
Powder Weight    14 grs
Primer    CCI 300
Brass Make    Remington
Barrel Length    6 (inches)
C.O.L    1.26 (inches)
Velocity    1670 fps
Group    3 (inches by 3 shot)
Submitted Date    2/14/2006 2:26:00 AM
Submitted By    Gloker
Gun Info    Glock 20

You could copy the load data in the Underwood pull-downs...read all of the data then decide what you want from your loadings

http://10mm-firearms.com/factory-10mm-ammo-pull-downs/underwood-135gr-sierra-jhp-pull-down/

http://10mm-firearms.com/factory-10mm-ammo-pull-downs/underwood's-lineup-135155165180220/

The (OLDER IMR800X data) did show using 14+ grains, but that data yielded by Hodgdon/IMR was pulled after recent testing showed flawed pressure data.  I know others that have shot this load buy results were 1800 fps from a Glock-20 but many have said it was not what they wanted in their pistols.  Therefore be very careful if attempting to use book loadings in this range.

Thanks shadow.   I will check them out.   I just received fed LPP so I dont need to use the LPM primers.

Thanks again

Brian