I HATE IT and I need a better and faster way to get uniform brass lengths. 

So how are you all doing it and with what.

Brian

There is company in MN I cannot remember the name but they have the slickest case trimmer I have ever seen and it works with a drill press. I will think on it and post when I come up with it.

SOunds interesting to say the least. 

THanks and looking forward to your info.

Brian

You ever try a Lee lock stud trimmer/bullet guide set up? Can't think of any easier way to do them. Don't need to set or measure for any cartridge once you get the correct guide, which are pretty cheap. I use them with the Lee three jaw chuck  (Actually made for the Lee Zip Trimmer) in my cordless drill for even more speed.

I must say , I never trim 10MM cases and do not have ANY problems.


Sean

Here you go this thing is cats meow.

http://www.littlecrowgunworks.com/wft.html

Quote from: 475/480 on July 11 2013 11:12:40 AM MDT
I must say , I never trim 10MM cases and do not have ANY problems.


Sean

I have yet to trim any straight walled case. And I have some 35+ year old .38 special cases I have reloaded a ridiculous amount of times. But if you are searching for EXTREME accuracy, I could see it.

I use the Lee Trim System too
Have the Zim Trim (which works well), but us a Cordless Drill (or Drill Press) if I'm doing a larger amounts

You know I was wondering about that if you guys are trimming straight walled cases.   I have done some minor trimming of my 445 supermag brass and my 41 gnr#2  but not much.   I always had to trim my 270 weatherby and had a hard time with uniform cases.  It was a PIA.

Thanks for the info guys.

Brian

Quote from: Ramjet on July 11 2013 03:28:29 PM MDT
Here you go this thing is cats meow.

http://www.littlecrowgunworks.com/wft.html

The Lee stuff looks just as easy and comes in MANY more calibers. To add a new caliber costs $6, quite cheap. I mean all it needs is a new bullet guide for a new caliber.

I just suggested it it is one of the fastest and easiest to use but your mileage may vary.

Quote from: 445 supermag on July 11 2013 09:15:17 PM MDT
You know I was wondering about that if you guys are trimming straight walled cases.   I have done some minor trimming of my 445 supermag brass and my 41 gnr#2  but not much.   I always had to trim my 270 weatherby and had a hard time with uniform cases.  It was a PIA.

Thanks for the info guys.

Brian

I don't. But I sure do on bottlenecked cases! The only straight walled stuff I have trimmed is 9mm luger when I converted it to 9mm mak and had to trim off one mm.