Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - JOHNP

#1
PICTURE OF JAVELINA

[attachment deleted by admin]
#2
I have one purchased in that time frame. It was stolen and gone for 16 years then recovered and returned to me. It sat in
the evidence room for 8 years before they got around to notifying me. Looked like it was never fired after it was stolen.
#3
10mm semi-auto handguns / Re: RIA1 BROKEN EJECTOR
September 27 2013 10:54:58 PM MDT
Finally got to the range fired 150 rounds no problems. we'll see if it makes it past the second 250. I suspect this was just a fluke.
#4
10mm semi-auto handguns / Re: RIA1 BROKEN EJECTOR
September 13 2013 11:10:48 AM MDT
Recieved my 10mm back from RI. The origional recoil spring was 16lb the new one is 20lb. I wont be able to get to the range for a couple of days because of the large amount of rain weve had.
#5
10mm semi-auto handguns / Re: RIA1 BROKEN EJECTOR
September 11 2013 10:38:57 PM MDT
I've been running 180gr jacketed bullets about 1000 fps for break in. The origional recoil spring was 16lb, I'll measure the new spring when the gun gets here tomorrow. The chamber is smooth. I sent the broken piece of the ejector back with the gun. We have been getting a lot of rain here so I'm not sure when I'll be able to get to the range, hopefully in the next few days.
#6
10mm semi-auto handguns / Re: RIA1 BROKEN EJECTOR
September 11 2013 09:07:53 AM MDT
My RIA1 is on the way back, should be here tomorrow (the 12th). They replaced the ejector, recoil spring and main spring and sent it to there gunsmith for a tune up. The made no comment as to why the ejector broke.
#7
10mm semi-auto handguns / Re: RIA1 BROKEN EJECTOR
August 23 2013 06:14:02 PM MDT
I have several  1911 45's and 1911 10mm which have fired several thousand rounds. There is no excuse for a broken ejector. I sent it back so they might figure out what happened and fix it.
#8
10mm semi-auto handguns / Re: RIA1 BROKEN EJECTOR
August 22 2013 03:44:24 PM MDT
They quoted 3 week max turnaround. The ejector is held in by two posts a larger diameter in front and a smaller diameter post at the rear and appears to be a press fit. Both posts sheared off level with the frame.
#9
10mm semi-auto handguns / RIA1 BROKEN EJECTOR
August 21 2013 10:28:34 PM MDT
Ejector broke on my RIA1 10mm after 250 rounds. Its on the way back for repair.
#10
BREN 10 SPECIAL FORCES

[attachment deleted by admin]
#11
10mm Javelina

[attachment deleted by admin]
#12
General Discussion / Re: Introductions
August 08 2013 05:52:02 PM MDT
The AMT longslide has a 7 in barrel
#13
General Discussion / Re: Introductions
August 08 2013 04:36:26 PM MDT
Hi John from Colorado. Just picked up my 4th 10mm a RIA1. Haven't shot it yet bad weather at the range. I also have a Bren 10 special forces model, a S&W 1006 and an AMT Javelina longslide. All were purchased new.