Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - hairbol

#1
10mm semi-auto handguns / Re: Semi with a 6” barrel
September 11 2020 04:10:25 AM MDT
The kodiak from DW is a nice gun.  Shoots very well and mine ran right out of the box.  Its quite accurate too.  You'll find that for reliability most manufacturers have settled on ramped (almost all) and bull barrel (a few less).  I will tell you I have an early N.O.S. 5 in 10mm built in the traditional way non ramped barrel and bushing and I spent a lot of time and effort and parts to make it run reliably. 

Sent from my SM-G975U using Tapatalk

#2
I have done a complete dis assembly and clean on this Razorback.  I find the barrel rifling most interesting.   The leading edge or left edge of the left hand rifling when viewed from the chamber is radius about half the length of the barrel.  It is normal at the crown.  The right is more vertical.  I have never seen this before.

Sent from my SM-G975U using Tapatalk

#3
I was able to pick up #102.  It has everything with it including test target, letter, brochure, case,etc.  Can't wait to test it.  Have you found a target load you like?

Sent from my SM-G975U using Tapatalk

#4
Striker delete should have read F.P. block delete.

Sent from my SM-G975U using Tapatalk

#5
Thank you for the feedback.  I may look into a Razorback.  I like my Guardian.  I do agree that only my pre 70 series NM and a Garthwaite built Commander I have shoot better than the Guardian and not by a lot.  Have a Tac ops that I've not had time to put together with accessories and break it in.  But once I do I expect it will become the new under headboard gun.  May look at the striker delete.

Sent from my SM-G975U using Tapatalk

#6
How do the DW Razorback pistols shoot?

Sent from my SM-G975U using Tapatalk