10mm-Auto

Other Ammunition Calibers => Factory Ammo => Topic started by: Kenk on December 15 2019 03:14:05 PM MST

Title: What are your favorite factory carry loads in 9, .45, and 10mm
Post by: Kenk on December 15 2019 03:14:05 PM MST
Mine are as follows

9mm - Federal HST 124gr + P / Speer Gold Dot 124gr + P, or Winchester Ranger T 124gr + P

.45 Auto - Federal HST 230gr + P /
Winchester Ranger T 230gr + P, or Underwood's 185gr GD + P

10mm Auto - Underwood's 165gr GD / UW's 135gr Nosler / Sig Sauer 180gr V Crown, or Speer Gold Dot 200gr

Ken
Title: Re: What are your favorite factory carry loads in 9, .45, and 10mm
Post by: sqlbullet on December 16 2019 07:33:16 AM MST
9mm - Remington 124 gr Golden Saber BJHP +p

40 S&W - 155 gr Speer Gold Dot

10mm - 180 gr XTP

45 ACP - 230 gr Federal 230 gr JHP +p
Title: Re: What are your favorite factory carry loads in 9, .45, and 10mm
Post by: Graybeard on December 16 2019 09:19:12 AM MST
9mm- Hornady 115gr Critical Defense

.45- Speer 230gr Gold Dots for short barrels, carried in a Kimber Ultra CDPII.

10mm- varies from urban to woods carry. Urban version is a 180gr XTP loaded to Underwood specs. Woods version is the same 180gr XTPs alternating every other round with 180gr RMR FMJ @ around 1320fps. These are mine, not factory.

.357 magnum- Barnes 125gr Tac-X-PD. In a 3" K6S. Lots of muzzle blast and recoil from these, but their expansion and penetration is excellent.
Title: Re: What are your favorite factory carry loads in 9, .45, and 10mm
Post by: Mike D on December 16 2019 07:56:52 PM MST
9mm - HST 124 +p on compact/mid size, HST 147+p on full size

45 ACP - HST 230+p

10mm - Underwood 180 Gold Dot


Sent from my iPhone using Tapatalk Pro
Title: Re: What are your favorite factory carry loads in 9, .45, and 10mm
Post by: Kenk on December 16 2019 10:17:00 PM MST
Nice...Thanks!

Ken
Title: Re: What are your favorite factory carry loads in 9, .45, and 10mm
Post by: sqlbullet on December 18 2019 08:58:06 AM MST
I am gonna augment this with the logic behind my selections.

First, I check out luckygunner.com's ballistics tests.  And then I pull up gunbot.net.  I compare price/round with ballistic performance and make a call from that data.  I don't mind a bit of penetration past the 18" FBI spec as long as I see good expansion.  The 9mm Remington load I picked does 18.5 average, but with one outlier pulling it up above 18".  The other four shots were just below 18", and the round expanded by nearly 100% (.66"). 

That is it.  The stuff on my list performed in a standardized gel test and was cheap on the day I ordered.
Title: Re: What are your favorite factory carry loads in 9, .45, and 10mm
Post by: Kenk on December 18 2019 09:11:42 AM MST
Absolutely, great info on luckygunner!
Title: Re: What are your favorite factory carry loads in 9, .45, and 10mm
Post by: The_Shadow on December 18 2019 10:24:56 AM MST
Remington 185 grain Golden Saber and Speer 230 Gold Dots in 45ACP
Speer Gold Dot 165, 180 and 200 grain and Hornady 180 and 200 grain XTP's in the 10mm
While I don't carry a 9mm I do like the 95 grain XTP & Gold Dot in the 380.  I do load many bullets for 9mm, 357 Sig and 9x25 Dillon but rarely carry those except woods carry or range play.
Title: Re: What are your favorite factory carry loads in 9, .45, and 10mm
Post by: 4given on December 18 2019 03:35:13 PM MST
9mm - Federal HST 124gr Standard pressure in my P365 and Federal HST 147gr standard pressure for everything else

.45 Auto - Federal HST 230gr standard pressure

10mm Hornady Custom 180 gr XTP
Title: Re: What are your favorite factory carry loads in 9, .45, and 10mm
Post by: Kenk on December 19 2019 05:48:47 PM MST
It's interesting that no one has mentioned Winchester Ranger T series in 124 + P / 9mm, or  Ranger T in 230 + P / .45 auto. At one point not long ago, I picked up a quantity of both, yet my carry weapons almost always have HST's or Gold Dots, Lol, that was a big waste of money...any thoughts on the Ranger T series in either caliber would be great
Thanks

Ken
Title: Re: What are your favorite factory carry loads in 9, .45, and 10mm
Post by: 4given on December 20 2019 08:27:31 AM MST
38 Special - 125gr Golden Saber
357 Sig Underwood 125gr Gold Dot
380 - Browning BPT 95 grain Flat Point
32 - Fiocchi 73 grain FMJ
44 Special 250 gr Keith Style SWC over 9 grains Power Pistol* or 7.5 gr Unique* (woods carry)

*These loads are over what is in the manuals and are shot only in My Ruger Blackhawk Lipsey Flat top 44 Special
Title: Re: What are your favorite factory carry loads in 9, .45, and 10mm
Post by: Squints08 on December 20 2019 09:05:52 AM MST
I only conceal carry 9mm firearms and they are all loaded with 124 grain Federal HST. I have confidence in them after personally using them against a coyote at 20 yards and witnessing the wound and speed of death. While carrying in the woods I carry a 10mm loaded with Underwood 200 grain XTP ammunition. I live in Illinois so larger/tougher predators are not my concern.
Title: Re: What are your favorite factory carry loads in 9, .45, and 10mm
Post by: Kenk on December 20 2019 09:20:59 AM MST
Plus the Underwood 200gr XTP would serve you well for two legged predators in the woods : )
Title: Re: What are your favorite factory carry loads in 9, .45, and 10mm
Post by: Kenk on December 20 2019 11:31:31 AM MST
From what I have read / watched, it sounds like Winchester's PDX1 may perform slightly better than the Ranger T  series, but have not done any actual testing
Thanks

Ken
Title: Re: What are your favorite factory carry loads in 9, .45, and 10mm
Post by: Velvetant on December 28 2019 01:28:22 PM MST
9mm - Federal HST 124gr in my G19 daily carry
10mm G20 I carry 180 XTP reloads when hunting/hiking
45ACP-Winchester Ranger T 230gr+P or Hornady 230+P XTP in my G21 when hunting/hiking.
I've used all these loads on coyotes and I'm very happy with the performance.

Where are you finding the 45ACP Winchester Ranger T 230gr+P?  Seems to be out of stock everywhere I look.
Title: Re: What are your favorite factory carry loads in 9, .45, and 10mm
Post by: Kenk on December 28 2019 02:22:15 PM MST
This place is great but you need to check every few days, looks like he's out as we speak. The prices aren't stellar, but they ship fast. He does have a 3 box min I believe. The guy is a Dr by day, and an ammo salesmen by night : )

https://www.eagleeyeguns.com/category-s/1835.htm


Ken
Title: Re: What are your favorite factory carry loads in 9, .45, and 10mm
Post by: Kenk on December 28 2019 02:50:43 PM MST
Afternoon Velvetant,
I just emailed John at Eagle Eye Guns regarding the 230gr Ranger T series +P availability, and will let you know
Thanks

Ken
Title: Re: What are your favorite factory carry loads in 9, .45, and 10mm
Post by: Velvetant on December 28 2019 02:54:11 PM MST
Thank you Ken.
Added myself to the be notified list.
Title: Re: What are your favorite factory carry loads in 9, .45, and 10mm
Post by: Velvetant on January 03 2020 02:34:51 PM MST
Quote from: Kenk on December 28 2019 02:50:43 PM MST
Afternoon Velvetant,
I just emailed John at Eagle Eye Guns regarding the 230gr Ranger T series +P availability, and will let you know
Thanks

Ken
Talked to John today and he said possibly next month.
We will send me an email when it arrives.
Randy
Title: Re: What are your favorite factory carry loads in 9, .45, and 10mm
Post by: Overkill338 on January 20 2020 10:14:02 PM MST
His
Glock 45 - Winchester Ranger T 127 +P+
Glock 32 - Underwood Gold Dot 125
Hers
Glock 33 - DoubleTap TAC-XP 115
Glock 43 - Winchester Ranger T 147
Title: Re: What are your favorite factory carry loads in 9, .45, and 10mm
Post by: Univibe on December 11 2020 12:37:10 AM MST
9mm is Q4318 Winchester NATO 124 grain.
Title: Re: What are your favorite factory carry loads in 9, .45, and 10mm
Post by: 10_fan on February 23 2021 06:23:28 PM MST
Quote from: Kenk on December 15 2019 03:14:05 PM MST
Mine are as follows

9mm - Federal HST 124gr + P / Speer Gold Dot 124gr + P, or Winchester Ranger T 124gr + P

.45 Auto - Federal HST 230gr + P /
Winchester Ranger T 230gr + P, or Underwood's 185gr GD + P

10mm Auto - Underwood's 165gr GD / UW's 135gr Nosler / Sig Sauer 180gr V Crown, or Speer Gold Dot 200gr

Ken

tried and true hornady xtp in everything I carry besides my 300 aac EDC, in that I use the hornady 125 grain hollow point sst ammo     take a look at this video, the penetration is amazing

https://m.youtube.com/watch?v=JrL72tsuAJc


Title: Re: What are your favorite factory carry loads in 9, .45, and 10mm
Post by: Alaska on February 20 2023 07:09:41 PM MST
10mm in Glock 20 trail gun
Underwood Hard Cast 220gr and 200gr XTP