Picked up the Limited Custom 9mm and went right to work cleaning it up. Swapped in the cone guide rod and flat bottom too.
(https://scontent-iad3-1.xx.fbcdn.net/v/t1.0-9/26047258_1637091866328839_2696383424551680227_n.jpg?oh=408ff563d36457415db6a1b61c9759ee&oe=5ABE8D13)
Limited Custom 9mm, Limited 9mm, Limited 10mm, Limited Pro 10mm and Hunter 10mm
(https://scontent-iad3-1.xx.fbcdn.net/v/t1.0-9/25994512_1637093826328643_2973099090266101287_n.jpg?oh=ad4d05f584c6b87b85e56322520eab68&oe=5AB6C259)
Very nice.
I wanted to double up on the Limited Pros. I should have went that route when I could.
Your picture makes me want to spring for a Limited Custom as I like the FLDC, but that Limited Pro is nice. Could even split the difference with a Stock II.
What's up with the rear sight on the Hunter?
Tony
Henning's fixed rear sight. I grew tired of the Super Sight moving.
Quote from: Intercooler on December 28 2017 06:19:47 PM MST
Picked up the Limited Custom 9mm and went right to work cleaning it up. Swapped in the cone guide rod and flat bottom too.
Just curious, I've never worked on any of the EAA's, (just a few CZ's) do the smaller frame 9mm's need the flat bottom FPS like the 10s or are they reduced enough in size & weight to warrant it? I haven't noticed any of the CZ shooters in USPSA "Production" division running them but they're running minor power factor ammo.
I know in 1911's, you normally have to go the opposite way and re-contour the FPS to get the angle higher to get reliable cycling.
Jeff
Everything is large frame. I put them in my 9mm's because I run a decent amount of +P+ ammo.
Just curious, Intercooler. Where did you source your flat bottom pin stops for your EAA? I've found some pin stops but none saying specifically that they are flat bottom or reduced radius. Thanks
Henning when he makes some, but recently EGW.
http://www.egwguns.com/slide-parts/eaa-firing-pin-stop-blue/
Thanks gents