Print Page - Arredondo Extension Jams

Title: Arredondo Extension Jams
Post by: rmbstyle on November 01 2015 08:42:58 AM MST

So I bought a Arredondo +5 magazine extension for my Glock 20 gen4. But everytime I install it, the follower will get stuck in the magazine about half way down and the rounds just fall out. I have tried it on all my magazines with the same result. They are using the #4 follower. Any suggestions?

Thanks

Title: Re: Arredondo Extension Jams
Post by: 4949shooter on November 01 2015 10:10:28 AM MST

I couldn't tell you. If you don't get an answer here, you might want to try the Tenring over on Glocktalk.

Title: Re: Arredondo Extension Jams
Post by: DenStinett on November 01 2015 03:33:38 PM MST

I run 5 of the Arredondo +5s on my MG20 (MechTech/Glock 20) Mags
My G20 is a Gen 2 (first Gen) Glock 20 and haven't have a single issue in several hundred Rounds
If you're not (accidentally) installing the Mag Spring backward, try bending the nose of the Mag Spring up a bit
Kinda like this:
(http://i197.photobucket.com/albums/aa176/rodslinger_2007/022.jpg)
(http://i197.photobucket.com/albums/aa176/rodslinger_2007/024.jpg)

10mm-Auto

Firearms => 10mm semi-auto handguns => Topic started by: rmbstyle on November 01 2015 08:42:58 AM MST