Print Page - 10MM eaa witness hunter brass

Title: 10MM eaa witness hunter brass
Post by: cdan on July 11 2015 09:12:51 PM MDT

what can be done to keep fired brass in the same area code?

Title: Re: 10MM eaa witness hunter brass
Post by: DenStinett on July 11 2015 10:11:16 PM MDT

Welcome to the Forum Cdan
You can try a heavier Recoil Spring
And / or re-facing the Ejector with a slightly downward and rearward / right facing angle

Title: Re: 10MM eaa witness hunter brass
Post by: sqlbullet on July 13 2015 03:36:49 PM MDT

Extractor shaping is the best bet.

Title: Re: 10MM eaa witness hunter brass
Post by: cdan on July 13 2015 04:46:16 PM MDT

Thanks,
Dan

Title: Re: 10MM eaa witness hunter brass
Post by: DenStinett on July 20 2015 08:22:12 PM MDT

Quote from: sqlbullet on July 13 2015 03:36:49 PM MDT
Extractor shaping is the best bet.

I believe you're thinking Ejector reshaping, not Extractor
Bevel the Ejector down and to the right a bit
Check here:
http://www.czfirearms.us/index.php?topic=8209.msg78580#msg78580

Title: Re: 10MM eaa witness hunter brass
Post by: sqlbullet on July 21 2015 01:23:36 PM MDT

yep...Brain fart or old age.

Do-hickey that hits the brass....

Here is a thread on the topic:

http://10mm-firearms.com/gunsmithing/eaa-witness-elite-limited-ejector-shortening-project/

10mm-Auto

General => Gunsmithing => Topic started by: cdan on July 11 2015 09:12:51 PM MDT