Just in case anybody is looking. I have a ton of both new and used cases myself, so I don't need any.
I think you meant Starline.
https://www.wideners.com/itemdetail.cfm?item_id=100000466&dir=278|282|908|927
You are correct. I just got done processing about 1000 Speer 357 SIG cases and my mind went into senior mode. ???
gandog, when you say processing are you talking about cleaning or other?
I have noticed all CCI and Speer 357Sig brass has very small flash holes...so small they will destroy most decapping pins.
Quote from: The_Shadow on January 22 2015 02:26:08 PM MST
gandog, when you say processing are you talking about cleaning or other?
I have noticed all CCI and Speer 357Sig brass has very small flash holes...so small they will destroy most decapping pins.
Yep, I heard on another board that somebody contacted Speer and they told them they got their 357 SIG brass from Lapua, and Lapua is sort of known for small primer flash holes. I don't have much Lapua brass, only some 7.62X54R rifle and those didn't damage any of my decapping pins. This SIG brass certainly did. Good thing that my Lee Universal decapping die pins are only 2 bucks to replace. I held up a Speer 357 SIG case and a Winchester 357 SIG case side by side, and yep, definitely an eyeball noticeable size difference between the flash holes.
The last batch of CCI/Speer 357Sig brass I drilled out, I used duct tape around my fingers to hold the brass as I drill about 700 cases...No blisters either! ;D
I just bought 500 pieces from Starline Brass and paid $95.00