Not really but I must be with my luck! ;D
- One S&W 22A frame
- One Dan Wesson Razorback slide release
- One EAA Witness Match rear sight
- One EAA Hunter rear sight
- One Walther P22 rear sight
- One XD-9 LPA rear sight
That's about it so far. When I get the new pieces I am sure the list will grow ???
My luck kind of sounds like yours, You sure go through more sites than me though. I guess I'm not shooting or trying hard enough. :o
Sights haven't been good to me. I think what the problem is the design for the recoil involved. My two revolvers shooting heavy Magnums have never had a sight issue!
So far, I have only lost a Firing Pin Block Lever on my CZ75B-SA
Not even the Gunsmiths at CZ could figure out how it happened
And the Trigger Bar Plunger / Magazine Release Pin broke off inside my Witness Frame
No one knew how it broke, but the Mags kept falling out of the Pistol
It was not warranted, and EAA sells it as an assembly, not just the needed Part (which really SUCKS)
Did you try Numrich for the Witness part? Brownell's carries a few things too.
Quote from: Intercooler on July 04 2013 05:45:47 PM MDT
Did you try Numrich for the Witness part? Brownell's carries a few things too.
Yeah, but it's the same thing for this part
It is only sold as an assembly
If you aren't breaking anything....you must be shooting a Glock!!!! :D